How to Use a Pool Pump

Using the pool pump may or may not be an easy task. But before going to that discussion, let’s firstrespond to the question, “How does a pool pump work?”

Pool pumps, regardless of the brand, typically do the exact same thing—sucking the water in and returning it back to your refreshing pool. By doing this, it keeps the pool crystal clear and sanitary.

Their horsepower affects the way they work. The higher the horsepower, the more suction you will get out of the pool. Remember that if you add more suction into your pool by incorporating pool cleaners or pool waterfalls, you need to purchase a new pump or increase its horsepower. If, however, you just moved into a new home, then the pump is likely to be correct for your pool.

Pool pumps work by using the pump motor to draw the water in through the pump intake and transfer it to the pump housing. The water will then go through a large debris basket where huge debris is caught, this way, it has no chance of clogging the pump system. The water will then go through the rest of the pump and will be discharged out to the filter.

Pool pumps circulate water from your pool through the filter and back to your pool. Located next to the filter in a concrete pit or recess below the water level of the pool, it allows the water to flow by gravity to the entry of the pump. Sometimes, if a heater is installed, the water also goes through it after it goes through the filter.

Take note that the debris basket should be cleaned properly in order for the pump to work efficiently.The rate ofdebris collected depends on your pool and its surroundings. Make sure the basket will only be accessed (by opening a strainer cover) after the pump is turned off.

A pump may run continuously to provide consistent filtration and circulation, maintaining the cleanliness of your pool water. However, if you want to conserve electricity, you may connect it to timers so that it will only work for limited hours.

Now, let’s move on to how a pool pump is used. You need to get it working in order to circulate the water in your pool and keep the chemical mixed. You don’t have to recirculate the water every day to remove debris since it can be removed using a vacuum or a skimmer. Reduce your filtration time to 6 hours a day and if the water doesn’t seem to be clean, increase the time in half-hour increments until it appears to be sanitary. You can also couple your pool pump with a timer to control the cycles.

Don’t forget to remove debris from the basket since clogged drains will need the pump to work harder, using more energy. Also backwash your filter properly. Forgetting to backwash will waste energy since it will require the pump to also work harder. But remember not to waste water, too, by backwashing more often than needed. If you still need a pool pump, we highly suggest that you read our popular pool pump reviews.